Epoxy & Polyaspartic Floor Installer Serving Atlanta, Fulton County
Atlanta is the most diverse market we serve. In a single week our crews might coat a Buckhead estate garage, a Virginia-Highland finished basement, a Grant Park detached garage from the 1920s, and a West Midtown restaurant floor along the BeltLine. Each of those jobs is a different concrete-prep problem, and each demands a different system spec. That range is exactly why homeowners and businesses across Atlanta pick a local specialist over a national franchise. Intown Atlanta concrete is old. Grant Park, Virginia-Highland, Inman Park, and Kirkwood are dense with pre-war homes on original stone foundations, and their basement slabs almost universally show moisture-vapor transmission and hairline cracking. We calcium-chloride test every basement slab older than 15 years and default to a moisture-tolerant epoxy primer whenever readings warrant it — this is the single biggest reason DIY and low-bid coatings peel within 18 months in intown Atlanta homes. Buckhead, Brookhaven, and Sandy Springs-adjacent neighborhoods lean toward larger 3-bay attached garages built between 1985 and 2015. These slabs are typically in good condition but were often broom-finished or lightly troweled, so we grind aggressively to open the surface before applying the pigmented epoxy base and full flake broadcast. Homeowners in these areas tend to spec design-forward finishes — metallic epoxies, custom flake blends, and darker charcoal palettes that coordinate with the interior of the home. On the commercial side, our Atlanta work concentrates along the BeltLine, in West Midtown, and in the Old Fourth Ward — restaurants, breweries, retail buildouts, auto shops, and creative office space. Commercial installs are almost always scheduled around your operating hours: after-hours grinding, overnight coating, drive-on the next morning. Every install includes tight dust containment and time-of-day-restricted logistics for tight intown alleys and shared loading docks.
Most Atlanta projects use our flake epoxy system finished with a polyaspartic topcoat. Showroom and feature-garage clients often choose metallic epoxy for a one-of-a-kind finish, while budget-conscious projects favor grind and seal.